Philips Jamie Oliver Schneideturm User Manual
Page 9
1
Put the ingredients in the feeding tube. (Fig. 7)
- Pre-cut large ingredients into pieces that fit in the feeding tube.
- Fill the feeding tube evenly for the best results.
- To shred cheese, e.g. Parmesan, Gouda or Emmentaler, the cheese should be at refrigerator
temperature.
Note: Certain ingredients may cause discolouration. If you spill ingredients on the outside of the Cutting
Tower, wipe away the spills immediately.
2
Put the pusher onto the ingredients in the feeding tube (Fig. 8).
3
Turn the control knob to speed 1 or 2 and push down the pusher. (Fig. 9)
Use speed 1 for soft ingredients like mushrooms. Use speed 2 for hard ingredients like carrots.
cleaning
Never use scouring pads, abrasive cleaning agents or aggressive liquids such as petrol or acetone
to clean the appliance.
1
Switch off and unplug the appliance.
2
Turn the lid with feeding tube anticlockwise to remove it from the bowl with spout.
3
Lift the disc holder and the tool holder out of the bowl with spout.
4
Remove the disc from the disc holder.
5
Turn the bowl with spout anticlockwise to remove it from the motor unit.
6
Clean the bowl with spout, the lid with feeding tube, the pusher, the tool holder, the disc
holder and the discs with warm water and some washing-up liquid or in the
dishwasher. (Fig. 10)
Clean the discs very carefully. The cutting edges are very sharp.
7
Wipe the motor unit with a moist cloth. (Fig. 11)
Danger: Never immerse the motor unit in water, nor rinse it under the tap. Do not clean it in the
dishwasher either.
Caution: If water or another liquid end up between the motor unit and the bowl with spout, dry
the motor unit properly before you use the appliance again.
storage
1
Wind the mains cord around the cord storage compartment facility in the bottom of the
motor unit.
2
Put the bowl with spout on the motor unit (1) and turn it clockwise (2) to fix it
(‘click’) (Fig. 2).
3
Put the tool holder in the bowl with spout (1). Put the lid with feeding tube on the bowl with
spout (2) and turn it clockwise (3) to fix it (‘click’) (Fig. 12).
4
Put the pusher in the feeding tube. (Fig. 13)
5
Store the appliance on a dry, flat and stable surface and the discs in a safe, dry place out of
the reach of children.
EnglisH
9