Billy Goat VQ802SPH - Manual (Page 13)

Part No. 830542 Form No. F021302G Page 13 of 16
16 OPERATION continued
Do not lift by hand. Use loading ramps or other mechanical assis-
tance. Secure in place during transport.
16.4 HANDLING & TRANSPORTING:
Never store engine indoors or in enclosed poorly venti-
lated areas with fuel in tank, where fuel fumes may reach an
open flame, spark or pilot light, as on a furnace, water heater,
clothes dryer or other gas appliance.
If engine is to be unused for 30 days or more, prepare as
follows:
Be sure engine is cool. Do not smoke. Remove all
gasoline from carburetor and fuel tank to prevent gum deposits
from forming on these parts and causing possible malfunction of
engine. Drain fuel outdoors, into an approved container, away
from open flame. Run engine until fuel tank is empty and
engine runs out of gasoline.
16.5 STORAGE
See DEBRIS BAG on page 6. 16.3
Diverter rod must
be in this position
for normal pickup.
Curb Guide
Rollers.
2" Front Guide
Wheels adjust
nozzle height to
keep it raised just
above cleaning
surface.
33" (838 mm)
wide nozzle. Casters - 8" (203 mm)
Dia. semi-pnuematic
tires with ball bearing
swivel.
Rear Wheels - Turf
Tread 13" Dia. x 6.5"
(330 mm x 165 mm)
wide pnuematic.
NOTE: Fuel stabilizer (such as Sta-Bil) is an acceptable
alternative in minimizing the formation of fuel gum deposits
during storage. Add stabilizer to gasoline in fuel tank or storage
container. Always follow mix ratio found on stabilizer container.
Run engine at least 10 min. after adding stabilizer to allow it to
reach the carburetor.