Braun 5596 - Manual (Page 6)

6
Optimal shaving performance
If using an electric shaver for the first
time, please bear in mind that your
skin may need about two weeks to
become fully accustomed to the new
shaving method.
Foil/cutterblock replacement
The shaver foil and cutterblock are
precision parts that, in time, are
subject to wear.
This wear is dependent on your
shaving method are beard type. To
maintain optimal shaving performance
you should consider replacing the foil
and cutterblock when worn.
This will ensure that you are getting
the close, comfortable shave you
expect from your Braun shaver.
Braun and the environment
For environmental reasons, your sha-
ver uses an «environmentally sound»
nickel-hydride recharging cell unit.
The cell unit does not contain any
poisonous heavy metals that can
damage the environment.
In the interest of recycling,
please do not dispose of this
appliance in the household
waste at the end of its useful
life. Instead, dispose of at an author-
ized Braun Service Center or at an
appropriate collection site.
Description
ᕡ
Charging pilot light
ᕢ
« Longhair trimmer » switch
ᕣ
«On/off » switch
ᕤ
Switch lock
ᕥ
Longhair trimmer
ᕦ
Cutterblock
ᕧ
Shaving foil frame
ᕨ
Foil protection cap
ᕩ
Cleaning brush
Switch lock
The shaver was delivered with the
switch lock activated (position
«lock»).
Push the switch
ᕤ
up before you shave
for the first time. To avoid accidentally
switching on the shaver, push the switch
lock to position «lock».
Cordless shaving/charging
When charging the shaver for the first
time, connect the shaver to an outlet
(100–240 V), via the cord, and charge
with the switch
ᕣ
set at «off», until the
charging light
ᕡ
goes off. The shaver
should be discharged through normal
shaving until it stops completely.
Caution: The opening of the shaver,
as described in the following
instruction, must be done only at the
end of the useful life of the shaver,
since the shaver is thus being
destroyed: For easy recycling this
shaver is equipped with a screw
mechanism in the plug socket.
Perforating the seal and turning this
mechanism opens the housing of the
shaver. It is recommended,
however, to take the shaver to a
Braun Service Center for this
purpose.
5596101_S&S_NA Seite 6 Dienstag, 20. August 2002 8:09 08