Braun D17525 - Manual (Page 5)

5
The Oral-B Professional Care has
been developed together with
leading dental professionals to
effectively remove plaque from all
areas of your teeth.
It adds a gentle pulsating action to
its oscillation to create a deep-
cleaning 3D brushing action.
It has been designed for daily use for
the whole family.
Please read the use instructions
carefully before first use.
Important
• Periodically check the cord for
damage. A damaged or non-
functioning unit shall no longer
be used. Take the charging unit
(e) to an Oral-B Braun Service
Centre.
• This product is not intended for
use by children under age three.
• If the product is dropped, the
brushhead should be replaced
before the next use even if no
damage is visible.
Description
a INDICATOR
®
brushhead
b Switch
c Handle
d Charge
indicator
e Charging unit
f Roll-stop
g Brushhead
compartment
(D 17 525 (X) only)
h Wall holder
i Interspace brushhead
(only with D
17 525 X model)
Specifications
Power supply:
see bottom of charging unit
Handle voltage: 1.2 V
Connecting and charging
The toothbrush is electrically safe
and can be used in the bathroom
without hesitation.
• Plug the charging unit into an
electrical outlet. Place the handle
on the charging unit.
• The charge indicator (d) flashes
while the handle is being charged.
• When the handle is fully charged,
the charge indicator lights
permanently. A full charge takes
at least 16 hours and provides an
operation time of approximately
45 minutes.
• For everyday use, the handle can
be stored on the plugged-in
charging unit to maintain the
toothbrush at full power.
Overcharging is impossible.
Battery maintenance
To maintain the maximum capacity
of the rechargeable battery, unplug
the charging unit and discharge the
handle by regular use at least every
6 months.
Using the toothbrush
This product can be used with any
leading brand of toothpaste.
To avoid splashing, guide the brush-
head to your teeth before switching
the appliance on.
Operating the switch
The toothbrush features two speed
options, the lower speed being
optimal for sensitive areas in the
mouth (A).
• Press the switch to operate with
normal speed,
• press a second time to operate
with reduced speed,
• press a third time to switch the
unit off.
Removing plaque
Guide the brushhead slowly from
tooth to tooth. Hold the brushhead
in place for a few seconds before
moving on to the next tooth.
Brush the gums as well as the teeth,
first the outsides, then the insides,
finally the chewing surfaces. Do not
press too hard or scrub, simply let
the brush do all the work.
Professional timer
With a signal you can
hear and feel, the timer
invites you to brush
quadrant by quadrant.
After every 30 seconds,
it signals by a very short stutter that
it is time to move to the next
quadrant. After two minutes – which
is the recommended brushing time –
the timer signals by a longer stutter.
Pressure Sensor
For safety and optimum brushing
results, the toothbrush has a pres-
sure control system:
If too much pressure is applied, the
oscillating movement of the brush-
head will continue, but the pulsation
will stop. In addition to feeling it, you
can also hear the difference.
During the first few days of using the
toothbrush, your gums may bleed
slightly. In general, bleeding should
stop after a few days. Should it
persist after 2 weeks, please consult
your dentist or hygienist.
INDICATOR
®
bristles
The INDICATOR
®
bristles help you
monitor and improve your brushing
performance. With proper brushing,
twice a day for two minutes, the blue
colour on the INDICATOR
®
bristles
will disappear half-way down within
3-4 months, signaling it is time to
change the brushhead (B).
Interspace brushhead
(only with D
17 525 X model)
The Interspace brushhead is
designed for cleaning between teeth
as well as around bridges, crowns
and implants. To use, position
brushhead at 45 degree angle to
gumline.
Slowly guide the brushhead along
the gumline, pausing between teeth
for optimum results.
Replacement brushheads
Available at your dealer or Oral-B
Braun Service Centres.
Cleaning
• Rinse the brushhead thoroughly
under running water for several
seconds with the handle
switched on (C).
• Switch off the appliance and
remove the brushhead from
the handle. Clean both parts
separately under running water,
then wipe them dry before you
reassemble the brush and put
the handle on the charging
unit (D).
• From time to time, also clean the
charging unit with a damp cloth.
• For cleaning purposes, the
brushhead compartment is
removable.
Subject to change without notice.
30
se
c
30
se
c
3
0
se
c
3
0
se
c
English
4736430_D17525/11_Korea Seite 5 Freitag, 8. Dezember 2006 10:35 10