Bissell 76T8 - Manual (Page 5)

5
w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1
Tool required: Phillips screwdriver
1. Slide upper handle onto unit. Insert one screw
into hole and tighten until snug. Screw will
be taped directly above cord wrap on back of
handle.
2. Wrap power cord around cord wrap.
3. Store crevice tool on back lower left side of
unit by snapping into place. Store the crevice
tool on vacuum as shown.
Foot assembly
No tools are required for assembly.
1. Slide foot pivot into suction path on body of
unit until pivot clicks into place. Ensure
connection is secure.
Hose assembly
1. Attach Twist ‘n Snap™ Hose by lining up tabs
on base with corresponding notches on the
back of the unit as shown.
2. Turn Twist ‘n Snap Hose to the right to lock
hose into place.
3. Loop hose around hose holders to keep in
place.
4. Insert smooth end of hose into hose base
located near the foot pivot on back of the unit.
Note: It is important that hose is fully
inserted into base for air to be directed
properly to foot during vacuuming.
A
ssembly
Crevice Tool
Hose Holders
ug110-4060_76T8_608.indd 5 ug110-4060_76T8_608.indd 5 6/18/08 3:43:55 PM 6/18/08 3:43:55 PM