Banner American Products BA-EN45 - Manual (Page 6)

u Do not operate the laminator with a damaged power supply cord or plug.
u Replace fuses only with same type rated 30A, 240V and 1A, 250V fuses. Contact your dealer
for replacement fuses.
u There are two (2) EMERGENCY STOP buttons on your Entry 4500, one on each side.
Depressing one of these buttons will stop the rollers.
III. Specifications...
Operating Speed: Adjustable to 5 fpm (2.54cm/sec.)
Power Requirements
Voltage:
Single Phase 208-240 VAC, 50/60 hz
Warm Up Time: 10-15 minutes
Fuse: 30 A
Maximum Laminating Dimensions
Thickness:
¼” (6.35mm)
Width Capacity: 45” (1143mm)
Net Weight: 260 lbs (120 kg.)
Shipping Weight: 360 lbs (165 kg.)
IV. Set-up...
Inspection:
Upon receipt of your Entry 4500, inspect the crate, the machine and all other contents of the crate for shipping
damage. Damage should be brought to the immediate attention of the delivering carrier.
Appropriate Location:
Your Entry 4500 must be placed on a sturdy table or stand in a clean, well lit area with ample space on all four
sides of the laminator. Contact your dealer for the optional stand designed especially for the Entry 4500.
Loading Film onto Mandrels
The following instructions apply to poly-in film rolls.
Top Roll: With the gripper spring away from you, pull the core gripper blade toward you and place the roll of
film onto the mandrel so that the film unwinds toward you from the bottom of the roll. Turn the roll on the
mandrel to lock the core gripper blade into the cardboard film core.
TOP MANDREL
3