Bracketron MVM Multi Vehicle Mount MVM-45-05 - Manual (Page 2)

IMPORTANT INFORMATION
••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••
MVM Instructions |
Page 1
IMPORTANT INFORMATION
Please read instructions completely before installing this Bracketron MVM Mount. All instructions are written from the drivers seat van-
tage point looking forward at the vehicles dash. We advise caution whenever you are removing or handling plastic parts of a vehicles
dash. WARNING: Unnecessary force or pressure can cause pieces to crack or break.
PARTS INCLUDED: MVM-45-05 Mount, 3 - #8x3/4” Self Tapping Screws, 2 - M4x8 Phillips Pan Head Screws, 2 - M4 Nylon Stop
Nuts, PHS-203 Ultra Slim Swivel and Mounting Hardware.
TOOLS NEEDED FOR MVM MODIFICATION (if required)
4 inch Mounted Bench Vise
12 oz. Ball Pein Hammer
Standard Tin Snips
Standard Hacksaw
Small File
TOOLS NEEDED FOR DASH PANEL DISASSEMBLY
Dash Trim Tool (Part #SIT-104)
# 2 Phillips Screwdriver
Fiskars 8511 Craft Hand Drill (recommended)
5/64” Drill Bit
9/32” Open End Wrench (for swivel)
Marking Pen
DASH DISASSEMBLY INSTRUCTION
••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••
Using a Phillips Screw Driver remove two (2) screws in the bottom of the
vents on the bezel around the radio. Note: You may need to rotate the
vents to access the screws. Place the screw in a safe place.
Using a Dash Trim tool (part #SIT-104) insert it behind the dash bezel
around the radio on the right side. Work our way around releasing a
total of nine (9) clips. Note: the climate controls are attached to this
bezel. Disconnect the wiring going to the clock and window switches.
Push the bezel off to the left side.
Skip to Step 6 on the following page if you have not yet formed the
bracket to fit your vehicle.
Place the MVM in the location as shown in the picture to the left. Use
a marking pen to mark the location of the hole. Carefully drill the hole
using a 5/64” drill bit and hand drill. Place the MVM over the hole and
insert the provided screw and tighten the mount down.
Carefully reinstall the dash in reverse order securing all screws and clips
to the bezel. Install the included Ultra Slim Swivel #PHS-203 to your Multi
Vehicle Mount or any other AMPs compatible device.
Your installation is complete
Install Mount Here
1
2
3
5
4
Note: The hole pattern on the face of the MVM maybe
different then what is shown in the pictures.