Billion Electric Company BiGuard 30 - Manual (Page 96)

96
Interface: Choose which WAN port to use: WAN1, WAN2
Packet Type: The particular protocol of Internet traffic for the specified policy.
Choose from TCP, UDP, or Any.
Source IP Range:
All Source IP: Click it to specify all source IPs.
Specified Source IP: Click to specify a specific source IP address and source IP
netmask.
Source IP Address: If Specified Source IP was chosen, here’s where the IP can be
entered.
Source IP Netmask: If Specified Source IP was chosen, here’s where the subnet
mask can be entered.
Destination IP Range:
All Destination IP: Click it to specify all source IPs.
Specified Destination IP: Click to specify a specific destination IP address and
Destination IP Netmask.
Destination IP Address: If Specified Destination IP was chosen, here’s where the IP
can be entered.
Destination IP Netmask: If Specified Destination IP was chosen, here’s where the
subnet mask can be entered.
Port Range: The range of ports for the specified policy (if you only want to use one
port, enter the same value in both boxes).
Click Apply to save your changes.