Connecting to the water supply, Connecting to the drain – Beko WM 5140 W User Manual

Page 10

Advertising
background image

EN

10

2. Adjust them until the machine

stands level and firm.

3. Important: Tighten all lock nuts up

again.

Connecting to the water

supply.

Important:

• The water supply pressure required

to run the machine must be 1-10

bar (0,1 – 1 MPa). (Practically, it is

necessary to have 10 – 80 liters

of water flowing from the tap in

one minute to have your machine

run smoothly.) Attach a pressure-

reducing valve if the water pressure

is higher.

• Connect the special hose supplied

with the machine to the water intake

valves on the machine.

• In order to prevent water leakage

that may occur at the connection

points, there are rubber seals (4

seals for the models with double

water inlet and 2 seals for other

models) attached to the hoses.

These seals should be used at the

tap and machine connection ends of

the hoses. The plain end of the hose

fitted with a filter must be attached

to the tap and the elbowed end

must be attached to the machine.

Tighten the nuts of the hose well by

hand; never use wrenches to tighten

the nuts.

• Open the taps completely after

making the hose connection to

check if there is any water leakage

at the connection points. Turn off

the tap and remove the nut in case

of any leakage. Retighten the nut

carefully after checking the seal.

To prevent any water leakage and

any other damage to be caused by

it, keep the taps closed when the

machine is not in use.

• Models with a single water inlet

should not be connected to the

hot water tap. Laundry may be

damaged or the appliance may

switch to protection mode and not

work.

When returning the appliance to its

place after maintenance or cleaning,

care should be taken not to fold,

squeeze or block the hoses.

Connecting to the drain

The water discharge hose can be

attached to the edge of a washbasin

or waste water system. The drain hose

should be firmly fitted into the drain as

to not loosen in its housing.

Important:

• The end of the drain hose can

be directly connected to the

wastewater drain or to the

washbasin. The fitting must be

secured in all types of connections.

Your house may be flooded if the

Advertising
This manual is related to the following products: