Binatone ACTION 950 - Manual (Page 5)

Binatone Help Line - 0845 345 9677
Your Action 950 can alert you to incoming signal by
n audible call tone signal.
Each channel also has 83 digital codes to let you set up
a group of users for more secured private communication.
a.
Press the MENU button 3 times. The current DCS code
flashes on the LCD screen.
b. Press the UP or DOWN button to select the desired DCS
code.
c. Press the PTT button to confirm the DCS channel setting.
3.3.2 Setting the DCS Advanced Digital Code
Transmitting and Receiving
The Action 950 transmission is “one way-at-a-time.” While
you are speaking, you can not receive a transmission.
The Action 950 is an open-license band. Always identify
yourself when transmitting on the same channel.
The unit is continuously in the Receive mode when the unit is turned
ON and not transmitting. When a signal is received on the current
channel, the “RX” icon will be displayed on the LCD Screen and
the receiver LED lights up.
a. Press and hold the PTT (push to talk) button to transmit
your voice. the “TX " icon will be displayed on the
LCD Screen and transmit LED lights up.
b. Hold the unit in a vertical position with the MIC
(Microphone) 5 cm away from the mouth. While holding
the PTT button, speak into the MIC (microphone) in a
normal tone of voice.
c. Release the PTT button when you have finished
transmitting.
3.5 Transmitting(sending speech)
3.6 Monitor
a. Press and hold the MENU and DOWN buttons at the
same time. The “RX” icon will be displayed on the
Action 950 w ill pick up signals on
b. Press the MENU button to stop the channel monitoring.
In VOX mode, the Action 950 will transmit a signal only when it
r sounds around you. The unit
will transmit for a further 2 second after you stop talking.
The level of VOX sensitivity is shown by a number on the LCD
Screen. At the highest level, the unit will pickup softer noises
(including background noise); at the lowest level, it will pick up
only quite loud noises.
3.7 Setting the VOX(Voice Activated)Sensitivity
a. Press the MENU button 4 times, the“ VOX” icon will
be displayed and “OFF” flashes on the LCD Screen.
b. Press the UP button to set the VOX sensitivity to
the required level (the maximum level is“ 3 ”.) To deactivate
the VOX function, press the DOWN button until “OFF”
appears on the LCD Screen.
c. Press the PTT button to confirm your setting. “VOX” will
steadily appear on the LCD Screen as long as the VOX
feature is activated.
VOX operation is not recommended if the Action 950 will be used in
is activated by your voice or othe
a noisy or windy environment.
3.4 Receiving
(Note: Monitor will not work in Dual Watch Mode.)
LCD Screen, and your
the current channel, including background noise.
emitting a