Behringer BX600 - Manual (Page 8)

8
ULTRABASS BX600
10 The PREAMP OUT allows you to drive an external bass amplifier.
11 Use the POWER AMP IN to feed in the output signal from an external bass amplifier.
+
The PREAMP OUT and POWER AMP IN connectors can also be used to insert an external
effects device such as our BEHRINGER VIRTUALIZER PRO DSP2024P. Simply connect the
PREAMP output to the input, and the POWER AMP input to the output of the effects unit.
12 The 1/4" stereo PHONES jack allows you to monitor the BX600’s audio signal with a pair of headphones.
Connecting the headphones will mute the built-in speaker.
13 The LINE OUT mono jack provides the audio signal of your ULTRABASS, for example, to send it to a
recording machine or line input on a mixing console.
+
You can also use the LINE OUT to connect a tuner.
14 Use the POWER switch to switch the BX600 on or off.
1.3.2 Rear panel
Fig. 1.3: Rear panel connectors
15 FUSE HOLDER / VOLTAGE SELECTOR. Please make sure that your local voltage matches the voltage
indicated on the unit, before you attempt to connect and operate the BX600. Blown fuses may only be
replaced by fuses of the same type and rating. Some models allow for inserting the fuse holder in two
different positions, in order to switch over from 230-V to 115-V operation, and vice versa. Please note
that for 115-V operation outside Europe, you need to use a fuse of a higher rating (see chapter 4
“INSTALLATION”).
16 Use the enclosed power cord to connect the unit to the mains.
17 SERIAL NUMBER. Please take the time to fill out and return the warranty card within 14 days after the
date of purchase, so as to be entitled to benefit from our extended warranty. Or use our online registration
option available on the World Wide Web at www.behringer.com.
1. INTRODUCTION