Blount ICS 613GC - Manual (Page 38)

© 2007 ICS, Blount Inc. F/N 71537 Oct 07
TITLE 613GC SERVICE MANUAL
36
12. CARBURETOR
12 This section covers the
removal and installation of the
carburetor. Removal of the air
intake components and cylinder
cover is required. Please refer
to sections 5 and 10 or 11 if
necessary. Carburetor tuning is
covered in section 23.
12.1 Remove throttle linkage.
A Push trigger end out of rear handle.
B Pivot linkage around.
C Remove carburetor end of linkage
from throttle rod tab on carburetor.
NOTE: All saws are equipped with
carburetor model # WJ-85A.
12.2 Remove choke lever split pin.
12.3 Remove choke lever.
12.4 Remove adjustment screw boot.