Hyundai H-2206 - Manual (Page 6)

6
· When the tape plays to the end on deck , deck will be playing automatically.
· When the tape plays to the end on deck , playing will be stopped automatically.
TAPE MIXING - USING DECK A AND DECK B
· You may like to mix the sound recorded on two cassette tapes together.
· Set function switch to tape position.
· Insert your prerecorded cassette tape in deck A and deck B as described in previous chapter.
· Start playback of both decks by pressing PLAY buttons on A and B decks simultaneously. You will obtain the wondrous audio effect.
RECORDING (DECK ONLY)
TAPE TO TAPE RECORDING
· Set the Function switch to TAPE position.
· Insert a pre-recorded cassette into deck and a blank cassette into deck .
· Press the RECORD button and PAUSE button on deck simultaneously.
· Press the PLAY button on deck .
· Release the PAUSE button on deck to start recording. Then both cassettes will start and dubbing at normal speed.
NOTE:
· Press the PAUSE button on deck
to pause the tape recording.
· Press the STOP/EJECT button on deck when the recording is finished.
· Set the Dubbing Mode switch to HI position if you wish to activate high-speed copying function. This will reduce the recording time to
about half.
NOTE:
· Do not reset DUBBING SPEED selector during dubbing.
· When the length of tape A is shorter than tape B, PLAY button of deck A is released automatically. But as RECORD button and PLAY
button of deck B are still being kept pressed, you have to press STOP / EJECT button to terminate the dubbing operation.
· When the length of tape B is shorter than tape A, RECORD button and PLAY button of deck B are release automatically at the end of tape
B. But tape A will continue to playback until it reaches its end.
RECORDING FROM RADIO
· Set the Function switch to RADIO position thus the Power LED indicator should light up.
· Tune to the desired station by turning the Tuning control regulator.
· Insert a blank cassette into deck .
· To start recording press the PLAY button and RECORD button on deck simultaneously.
· Press the STOP/EJECT button when finished.