Bravetti GLASS DEEP FRYER K4305H - Manual (Page 4)

GETTING TO KNOW YOUR DEEP FRYER OPERATING INSTRUCTIONS
Warning: Always remove the
plug from the wall socket before
cleaning. Allow the deep fryer and the oil
to cool completely (approximately 2
hours) before cleaning. Never immerse
the control panel, cord or plug in water or
any other liquid.
• Follow the cleaning instructions on
page 3. (Before using for the First
Time)
• Never immerse the control panel, cord
or plug in water or any other liquid.
• Do not place the control panel, cord or
plug in the dishwasher.
• Clean the control panel only with a
damp cloth.
• The frying basket, glass lid with the
filter can be washed in the dishwasher.
• Wash the glass oil container with
warm, soapy water. Do NOT place in
dishwasher.
• The body of the deep fryer can be
washed in warm soapy water. Do not
put the body of the deep fryer in the
dishwasher.
• After washing the glass lid, make sure
that it is free of any water. See
illustration below for best position to
drain water from the glass lid.
• Any other servicing should be
performed by EURO-PRO Operating
LLC.
Cleaning Instructions
The female receptacle portion of the
power supply cord is permanently
attached to the rear of the the control
panel.
To connect the male power cord plug to
the female receptacle on the appliance,
orient the male plug so that it mates
with the female receptacle. The male
plug can only be inserted one way. If
the male plug will not go into the
receptacle on the appliance, rotate the
male plug 180°
IMPORTANT: Should the male plug
become detached from the appliance
during use, it is important to:
1. Unplug the power cord from the wall
outlet.
2. Turn the temperature
control knob to the
lowest heat setting.
3. Re-attach the power
cord to the appliance.
4. Re-connect to power
outlet.
5. Turn the
temperature
control knob
to the desired temperature setting.
If for some reason the deep fryer stops
heating, the reason might be that the
safety reset switch has been tripped. To
re-set the deep fryer, follow the
following instructions:
1. Turn the temperature control knob
counter clockwise to the lowest heat
setting.
2. Remove the plug from the electrical
outlet.
3. Let the deep fryer cool for a
minimum 15 minutes.
4. Replace the power cord
into the electrical outlet.
5. Push the reset button
located on the side
of the control panel.
(see illustration)
6. Reset the temperature
control knob to the
desired heat temperature
and proceed with frying.
Reset
Button
How to Reset the Deep Fryer
10. Main Housing
11. Basket Handle
12. Frying Basket
13. Guide Rails
14. Moisture Container
15. Magnetic Power Cord
16. Magnetic Power Cord Socket
17. Reset Button 1. Lid Handle
2. Air Outlet Vent
3. Glass Lid
4. Power “ON” Indicator Light
5. Temperature Ready Light
6. Temperature Control Knob
7. Control Panel
8. Heating Element
9. Glass Oil Container
Detachable Magnetic Power Cord
Your Deep Fryer has been specifically
designed with your safety in mind. Your
deep fryer has a unique detachable
power supply cord. This power supply
cord cord is designed to “Break Away”
from the fryer body in the event that the
supply cord is inadvertently pulled.
This is intended to prevent the tipping
of the appliance and hazardous spillage
of hot oil.
Technical Specifications
Voltage: 120V., 60Hz.
Power: 1800 Watts
Oil Capacity: 3 Liters
2 7