Blaupunkt DRESDEN RCR 128 User Manual

Page 7

Advertising
background image

23

ENGLISH

DEUTSCH

FRANÇAIS

ITALIANO

NEDERLANDS

SVENSKA

ESPAÑOL

PORTUGUÊS

Setting the tone:
Select the audio mode. Press AUD
once and set the tone using the rocker
switch.

Treble:

Treble +
Treble –

Bass:

Bass –
Bass +

Press AUD twice and set the fader
using the rocker switch.

Fader front
Fader rear
Balance left
Balance right

The selected values will appear in the
display. The last setting is stored auto-
matically.

Switching AUD off
Press button briefly.
If you do not change the tone within
8 sec., the AUD mode will quit auto-
matically.

Extra function: LD
Loudness boosts the bass frequency
at low volume.
Press AUD longer than 2 seconds to
change the Loudness setting. “LD” will
appear.

Important notes

What you need to know

Before using your new car radio, please read
through the following information carefully.

Traffic safety

As the driver of a motor vehicle, it is your
responsibility to pay attention to the traffic
situation at all times.
Never use your car radio in a way that could
distract you.
Please keep in mind that you travel a dis-
tance of 14 m per second at a speed of only
50 km/h.
Should the traffic situation become particu-
larly demanding, we advise you not to use
the radio.
Always make sure that you are still able to
hear any warning signals coming from out-
side the vehicle, such as police or fire en-
gine sirens, so that you can react accord-
ingly.
Consequently, you should always select a
moderate volume for playing your car radio
while you are driving.

Installation

If you would like to install your new car ster-
eo yourself or add other audio components
to existing ones, then please read the en-
closed instructions on installation and con-
nection carefully.
In order to ensure that the set operates prop-
erly the positive power supply line must be
connected via the ignition and the perma-
nent +12 V lead.
Do not ground the loudspeaker outputs!

Warning note

Danger of damaging the automatic
power antenna in a car wash

Before you drive into a car wash

switch the radio off by pressing the ON
button.
The power antenna will retract, if it
doesn’t, press ON again.

Do not drive into the car wash unless the
power antenna has retracted!

Dresden,Boston RCR128 gb®

02.05.2002, 11:03 Uhr

23

Advertising
This manual is related to the following products: