Becker Designed AR 3201 - Manual (Page 26)

Controls and indicators Description Function
Channel selector 5-position rotary switch Position A :
When the transceiver is powerd
up, a brief test routine is
performed for the segments of
the display. Afterwards the
channel frequency 121,500 MHz
appears in the display and the
transceiver is ready for
operation. In models with serial
no. of 4000 or above, the moste
recently set frequency instead of
121,500 MHz.
The setting of channel
frequencies is performed with
the channel selector switch in
position A, regardless of the
units serial number
Position 1 through 4 :
If is wished to store a channel
frequency in any one of the four
memory locations, then channel
frequency to be stored must first
be set with the frequency
selector switch in position A.
Then the desired memory
location is selected using the
channel selector switch, and the
Store button is pressed.
Stored channel frequencies
remain in the memory even,
when the unit is powered down
and can be immediately called
up again after the unit has been
switch on.
MHz frequency selector switch Rotary switch (continuous) Switches the MHz steps
indicated by the frequency
readout.
kHz frequency selector switch Rotary switch (continuous) Switches the 25 kHz steps
indicated in the frequency
readout. The 3rd digit behind the
point is not indicated, e.g.
125.52 = 125.525 MHz.
Frequency indication LC display 5 digits When the unit switched on,
following completion of the self-
test routine the frequency
appers in the display on which
the unit is ready to operate.
During transmission, in models
with serial no. 4000 or above
arrow also flashes on and off.
AR 3201 - ( )
Page 3-2 DV 28110.03/04 Issue 02/92