Beltronics GX65 - Manual (Page 10)

Details of Programming
16 17
Pilot Light (Power-on indication)
PilotHWY (Full word)
In this setting the GX65 will display
“Highway,” “AutoScan,” or “AutoNoX” as its
power-on indication. (factory default)
Pilot H (Letter)
In this setting, the GX65 will display “H”
for Highway, “A” for AutoScan and “ANX”
for AutoNoX.
Pilot V (Vehicle voltage)
In this setting, the GX65 will continually
display “H” for Highway, “A” for AutoScan
and “ANX” for AutoNoX plus the vehicle’s
battery voltage.
NOTE: If the vehicle’s voltage
drops below 10.5 volts, a low voltage
warning is displayed, followed by an
audible alert. A high voltage warning
is also given if the voltage goes above
16.5 volts. The high-voltage warning is
also followed by an audible alert.
Pilot SPD (Vehicle speed)
In this setting, the GX65 will continually
display “H” for Highway, “A” for AutoScan
and “ANX” for AutoNoX plus the vehicle
speed.
Signal Strength Meter
MeterSTD (Standard meter)
In this setting, the meter displays the band
of the received signal, and a bar graph
shows the relative signal strength. (factory
default)
MeterTHT (Threat Display)
In this setting, the meter simultaneously
tracks multiple radar signals. It can display
mulitple radar signals and their signal
strength at the same time.
NOTE: The Threat Display feature
is explained in more detail on pages
12-13.
NOTE: Ku band is displayed as an
X-band signal.
NOTE: If a Marker and a real
threat are encountered at the same
time, the display will alternate
between the meter and type of marker
being reported.
MeterTEC (Tech Display meter)
In this setting, the meter displays the
actual numeric frequency of the radar
signal received.
NOTE: The Tech Display feature is
explained in more detail on page 13.
AutoMute
aMute ON (AutoMute on)
In this setting, the GX65’s audio alerts will
initially be at the volume you set, but after
a few seconds the GX65 will automatically
reduce the volume level to keep you
informed, but at a lower audio level.
(factory default)
aMuteOFF (AutoMute off)
In this setting, the GX65’s audio alerts will
remain at the volume you set for the
duration of the radar encounter.
Units
Units ENG (Speed measured in
miles per hour)
In this setting, all speed related features
are displayed in miles per hour (MPH).
(factory default)
Units MET (Speed measured in
kilometers per hour)
In this setting, all speed related features
are displayed in kilometers per hour
(KPH).
Speed Check
Spdck ON (Speed Check on)
In this setting, your vehicle’s speed will be
displayed for a few seconds during an alert.
After a few seconds, the GX65 will display
the meter type you have selected, (e.g. bar-
graph, Threat Display or Tech Display.
(factory default)
SpdckOFF (Speed Check off)
In this setting, the GX65 will display the
meter type you have selected.