Buffalo Technology WBR2-G54 - Manual (Page 53)

53
no longer have access to the AirStation confi guration screens. This function prohibits setup from
a wireless or wired computer. The AirStation can be returned to the factory default settings by
holding down the INIT button on the back of the unit for fi ve seconds or until the red DIAG light
becomes solid.
Protocol - Mark and select a specifi c protocol. Select from all protocols, ICMP, arbitrary protocol
number and TCP/UDP protocol number.
•
All - Selects all IP protocols.
• ICMP - Network Diagnostic Protocol (1).
• Manual - Enter protocol number (0-65535).
• TCP/UDP Destination Port - Select TCP or UDP, then enter port number.
Priority - Specify the priority an item. The smaller the number, the higher the priority.
MAC Filter - Click Enter MAC
fi lter to enter MAC address.
Source MAC address -The
MAC address of the source of
the packets that will be fi ltered
may be set. Click Add rule
when complete.
Advanced Settings
Add MAC
Filter
setting