4start, Aerial connection, Powering on your tv and the initial use – Beko 22WLP530HID User Manual

Page 8: Batteries

Advertising
background image

6

4

Start

Remove your television carefully from its

box. You can keep the packaging of your

television to use in future.

Contents of the box

Power cable (*)

Remote control

2 batteries

Note: The Scart, VGA (*) and PHONO cables

are not supplied with the device.

(*) These features are optional and may not

be available on all models.

4.1-Aerial connection

If you use a 75 Ohm coaxial cable (round

cable) as an antenna cable, connect the

antenna plug directly to the antenna input

located on the TV.

Motorized vehicles, energy lines and

telecommunication lines affect your antenna.

Therefore, be careful to install your antenna

away from these and metal surface in such

a way that it shall not swing. Do not make

your antenna cable longer than required

and do not coil it. Make sure that it is not

crimped passing through a window or door.

Your antenna and cable might be affected

by natural phenomena such as rain, wind,

smoke and humidity over time. Periodically

check your antenna and equipment.

4.2-Powering on your TV and

the initial use

1. Insert the power cable into the appropriate

power supply input located on the back

panel of the LCD TV.

2. Insert the plug of the mains lead , supplied

with the device into the mains socket.
Note 1: Your TV will switch to the stand-by

mode in five minutes if there is no broadcast

signal from aerial.

3. To power on your television, press

any numerical key or

P+ or P- keys

on the remote control.

Note: If you are not going to use your

television for a long time, unplug its power

cable from the socket.

Initial power on and performing

settings

To set up your television, read the sections

on the TV controls and making the channel

settings.

4.3-Batteries

Open the lid of the battery compartment

and make sure that you have placed the

batteries in the correct direction. For this

remote control, UM-4, IEC R03 or AAA 1.5 V

batteries are suitable.

Do not throw your old batteries into the fire,

discard them in a dedicated waste area for

this purpose.
Do not mix used batteries with new ones or

different types of batteries together.
The performance of the remote control will

be reduced at a distance of 8 meters from or

at an angle of 30 degrees beyond the centre

of the TV.

Advertising