Billy Goat P / N 440120 - Manual (Page 9)

Part No 440021 Form No F101706A 9
FORCE BLOWER Owner’s Manual
ASSEMBLY
Figure A
Figure B
1.Follow the steps in figures A and B, then securely tighten all hardware shown.
2.Connect spark plug wire.
The hardware for attaching the upper handle to the lower
is in the parts bag. Install upper handle (item 30), to
preassembled lower handle (item 28) by sliding the upper
over and down the outside of the lower handle. Using bolt
(item #36), washers (item #10) & lock nut (item #11) to
install upper handle to lower handle. Finish installing the
other side of the upper handle assembly using screw and
lock nut provided. The throttle control will be attached to the throttle arm on
the engine and wrapped around the engine for shipping.
Unwrap and secure throttle control (item #31) to upper
handle with screws (item #39). Screws will already be
mounted in handle, simply remove and use to mount the
throttle control.
Two ½” open ended wrenches One 3/8 open ended wrench