Bissell 68G9S - Manual (Page 10)

10
w w w . b i s s e l l . c o m
M
aintenance and care
Dust bag replacement
1. Unplug the vacuum from electrical outlet.
2. Open the dust bag compartment by lifting up
on the latch on the door on the front of the
vacuum.
3. Lift out the dust bag holder and dust bag.
4. Release the dust bag from the holder by
pressing the dust bag holder clip and pulling
the dust bag out of the holder. Discard the
used dust bag.
5. Slide the new dust bag into the holder by
inserting the dust bag into the tabs located
at the bottom of the holder. Then press the
dust bag holder clip, insert the dust bag and
release the dust bag holder clip to hold the
dust bag in place.
6. Place holder and new dust bag back into
the dust bag compartment, making sure
the entire bag is tucked in below the seal
gasket.
7. Close dust bag compartment door and press
down gently until it locks into place.
notE: the dust bag compartment door will
not close without the dust bag in place.
2.
3.
4.
WaRnInG:
to reduce the risk of
electric shock, turn
power switch off and
disconnect plug from
electrical outlet before
performing maintenance
or troubleshooting
checks.