BIONAIRE PERMAtech BAP1700C - Manual (Page 5)

9
1. Press the TIMER button until you reach the desired
number of hours you want the unit to operate (2, 4, 6
or 8)
• The number of hours selected will light up and
remain illuminated on the control panel.
• When time is up, the air cleaner will beep 3
times and turn off.
2. To CANCEL the timer, press the TIMER button one
more time. You may also cancel the timer operation
by turning the power button off.
CLEANING AND
MAINTENANCE
CLEANING THE PERMAtech ® FILTER
The PERMAtech ® filter is designed to never need
replacement. However, we recommend regular cleaning
for optimal performance.
• Every few weeks, check the condition of the filter.
• After approximately 3 months of operation, a Filter
Clean Indicator will alert you to clean the filter before
further use.
To clean the filter:
1. Turn off and unplug the air cleaner.
2. Remove the air inlet grill by pulling on the tab.
3. Remove and examine the foam pre-filter.
• If it has collected dust or lint, remove and wash it
in warm soapy water. Rinse and drip dry
thoroughly before placing it back into the grill inlet.
4. Check the condition of the PERMAtech ® filters and
remove if dirty.
5. Clean the PERMAtech ® filter.
• Using your vacuum cleaner,
run the brush attachment
along both sides of the filter
and clean between the
pleated layers (Figure 2).
IMPORTANT: Do not use water, household cleaners
or detergents to clean the PERMAtech
® filter.
8
A. Inlet Grill
B. Washable Foam
Pre-Filter (1)
C. PERMAtech ®
Filter (2)
D. Filtered Air Outlet
E. Control Panel
F. Filter Check LED
G. Filter Reset Button
H. Timer Button
I. Timer Leds (4)
J. Ionizer Button
K. Power Button
L. Power/Mode LED’s (3)
M. Auto Button
D
A
C
Figure 1
B
F
H
J
K
M
E
I
L
Figure 2
G
BAP1700_08EM1.qxd:BAP170008EM1 V.qxd 4/14/08 9:09 AM Page 9