New Buck Corporation 329 - Manual (Page 27)

WARNING:
ELECTRICAL GROUNDING INSTRUCTION:
THIS APPLIANCE IS EQUIPPED WITH A THREE-PRONG (GROUNDING) PLUG
FOR YOUR PROTECTION AGAINST SHOCK HAZARD AND SHOULD BE
PLUGGED DIRECTLY INTO A PROPERLY GROUNDED THREE-PRONG
RECEPTACLE.
NOTE: #PESBR084 Blower Motor
Rating: 120 volts/60HZ/1.1 Amps.
See Figure 6, page 22 for wiring diagram.
NOTE: For convenience, allow licensed electrician to install properly grounded
3-plug receptacle near unit.
ROOM BLOWER INSTALLATION AND OPERATION INSTRUCTIONS
The room air blower is located at the rear of the unit in the bottom chamber. To remove or
replace blower, open lower louvered access door. The motor is located right center in rear.
Remove the two (2) hex head screws holding the motor and motor bracket to the outer bottom
of the unit. Unhook the two motor wires and remove the motor from the unit. Next remove the
(2) screws that fasten the motor bracket to the motor. Locate the motor bracket on the new
motor in the same position as with the old. Using the two (2) hex head screws fasten the
bracket to the new motor. Place new motor into the lower compartment.
NOTE: Make sure the motor opening 1"x 5" is behind the inner wall of the stove and not
touching any metal. Fasten the new motor and bracket to the motor support on the bottom of
the unit. Hook the motor wires as shown in the diagram on page 22.
Installation and repairs should be performed by a qualified service person. The appliance should
be inspected before use and at least annually by a professional service person. More frequent
cleaning may be required due to excessive lint from carpeting, bedding material, etc. It is
imperative that control compartments, burners and circulating air passageways of the appliance
be kept clean.
Page 23