General configuration, Scanning mode selection, Good read beeper tone selection – Baracoda BL2604 User Manual
Page 7: Sound duration, 4 general configuration, 1 scanning mode selection, 2 good read beeper tone selection, 3 sound duration
BC/BL/BLR2604 Programming Guide
4 General configuration
Start of Configuration
4.1 Scanning mode selection
The scanner becomes inactive as soon as the data is
transmitted. It must be triggered to become active
again.
In auto scan mode, the scanner is still active after the
data is transmitted, but the successive transmission of
the same bar code is not allowed when the trigger
switch is pressed again.
Trigger mode
Auto scan mode
4.2 Good read beeper tone selection
You can use this option to set frequency and / or duration of the buzzer after successful reading.
Low
Medium
High
Disable
4.3 Sound duration
long(120 ms)
Medium(50 ms)
Short(20 ms)
Very short(5 ms)
End of Configuration
© Baracoda 2004
Page 6/22