Philips TSU9200-37 - Manual (Page 9)

EN
G
LI
SH
9
Preparing for Configuration
3.3 Preparing Your PC
In the box you find an installation CD for the Configuration Program.
To install the Configuration Program:
Insert the CD in the PC and follow the instructions on the screen.
D Notes
It is advised to check for updates for the Configuration Program. See
www.pronto.philips.com in the Downloads section (PC Software).
You can
install the Configuration Program next to other Philips Pronto editors on the
same operating system. Your files are automatically placed in a separate directory.
To uninstall the Configuration Program, use the Windows uninstall feature.
(Start > Control Panel > Add/Remove Programs)
D Note
It is recommended to back up MyDatabase and the configurations regularly.
4 Configuring the Pronto Remote Control
4.1 Using Pronto Dashboard
Pronto Dashboard is the starting point for managing configurations for a wide variety of
Pronto Remote Controls. It presents the tasks you can perform depending on the installed
programs:
• New Project Wizard.
• Manage MyDatabase. See Managing MyDatabase on page 12.
• Classic ProntoEdit to configure other products of the Pronto line.
4.2 Using the Wizard to Configure the Remote Control
The Configuration Program is a wizard for configuring the TSU9200. It is very easy to use
and it creates a valid configuration in just a few steps.
To start the wizard:
Select the New Project wizard in Pronto Dashboard.
-or-
Start the wizard from the Windows Start Menu.