Bose AM262840 - Manual (Page 12)

10 January 4, 2002 AM262840_00_V.pdf
Setting Up Your Lifestyle ® Stereo Amplifier
Setting up the remote control
You need to set up a second remote control to operate the ZONE 2 output.
1. Remove the remote control battery cover and locate the miniature switches (Figure 9).
2. Make sure that the house code settings (switches 1, 2, 3, and 4) match those in your first remote.
3. Make sure switches 5, 7, and 8 are up, and switches 6 and 9 are down.
Note: Refer to your Lifestyle ® system owner’s guide for more information on operating your system in more
than one room.
Figure 9
Setting up a Zone 2 remote
control
Setting Zone 2 Protocol
For the SA-1 amplifier to work properly with a Lifestyle ® media center, you will need to set the Zone 2 Proto-
col to Legacy mode (Figure 9a).
1. While your Lifestyle ® DVD system is on, press the Settings button on your remote control. This will open
the on-screen display.
2. Scroll down with the down-arrow button and select System Setup using the enter button.
3. You will now see a menu entitled System Setup (1 of 3). Scroll down to “more...”. Continue to scroll down
through (2 or 3) to (3 of 3). The last item on System Setup (3 of 3) is Zone 2 Protocol.
4. Use the right-arrow button to change the protocol from Normal to Legacy.
5. Before using Zone 2, shut off the system and turn it on again; this ensures that the Zone 2 Protocol is
reset to Legacy mode.
ON
Settings ( )
System Setup
System Setup (3 of 3)
Zone 2 Protocol: Legacy
SOURCE / INPUT
MENU / NAVIGATION
Seek
Channel
Chapter
Preset Track
Volume
Stop Pause Play PLAYBACK
Tune
Disc
On
Off Mute All Mute
CD/DVD Changer FM/AM
Settings
Enter
1 2 3
4 5 6
7 8 9
0
Shuffle Repeat
TV VCR AUX
Settings
Enter
Figure 9a
Setting Zone 2 Protocol