Braun 5745 - Manual (Page 5)

5
Our products are designed to meet the
highest standards of quality, functionality and
design. We hope you enjoy your new Braun
Shaver.
Warning
Your shaver is provided with a special cord set
with integrated Safety Extra Low Voltage
power supply. Do not exchange or manipulate
any part of it. Otherwise there is risk of electric
shock.
Description
1 Shaver foil
2 Cutter block
3 Release button
4 On/off switch («start/stop»)
5 Long hair trimmer
6 Charging light (green)
7 Special cord set
Charging
The best environmental temperature for
charging is between 15 °C and 35 °C.
• Connect the shaver to an electrical outlet
with the motor switched off and charge it
for at least 8 hours.
• The green charging light (6) shows that the
shaver is being charged.
• Once the shaver is completely charged,
discharge the shaver through normal use.
Then recharge to full capacity.
• A full charge provides up to 30 minutes of
cordless shaving time depending on your
beard growth. However, the maximum
battery capacity will only be reached after
several charging/discharging cycles.
Shaving
Press the on/off switch (4) to turn the shaver on.
Trimmer:
When the long hair trimmer (5) is activated, it
allows the controlled trimming of moustache
or sideburns.
Cleaning
This appliance is suitable for cleaning
under an open water tap.
Warning: Detach the hand-held part
from the power supply before cleaning it in
water.
Regular cleaning ensures better shaving
performance. Rinsing the shaving head after
each shave under running water is an easy
and fast way to keep it clean:
• Switch the shaver on (cordless) and rinse
the shaving head under hot running water.
A natural based soap may also be used
provided it contains no particles or
abrasive substances. Rinse off all foam and
let the shaver run for a few more seconds.
• Next, switch off the shaver and press the
release buttons. Remove the shaver foil
and the cutter block. Then leave the
disassembled shaving parts to dry.
Alternatively, you may clean the shaver using
the brush provided:
• Switch off the shaver. Remove the shaver
foil.
• Using the brush, clean the cutter block and
the inner area of the shaver head. However,
do not clean the shaver foil with the brush
as this may damage the foil.
Tips for the perfect shave
• We recommend that you shave before
washing, as the skin tends to be slightly
swollen after washing.
• Hold the shaver at right angles (90°) to the
skin. Stretch the skin and shave against
the direction of beard growth.
• To maintain 100% shaving performance,
replace the shaver foil and cutter block at
least every 18 months or when worn.
English
5745459_Korea_4835 Seite 5 Freitag, 22. Juni 2007 12:47 12