Hyundai H-1205 - Manual (Page 5)

5
· Press the STOP/EJECT button when finished.
NOTE:
· You may want to monitor playback during recording. You can adjust the sound with the VOLUME control. This adjustment does not affect
the content of recording
RECORDING WITH BUILT-IN MICROPHONE
· Slide the Function switch to MIC position.
· Insert a blank cassette into deck with the tape-side up.
· Press the PLAY button and RECORD button simultaneously to start recording.
· Press the STOP/EJECT button when finished.
NOTE:
· Monitoring during MICROPHONE recording is not possible
MAINTENENCE AND CARE
· Check your batteries regularly, old or discharged batteries should be replaced. If the unit is not going to be used for some time or is being
run exclusively on the alternative power, remove the batteries to avoid leakage and damage.
· Electronic products of this kind should never be subjected to moisture or extreme temperatures.
· If necessary, clean the unit with a piece of cloth dampened with water only (be sure the AC power cord is disconnected from the power
supply).
· The heads and capstan are in constant contact with the moving tape. Use a small cotton bud with alcohol or special tape head cleaner to
clean these parts. Never touch the heads with anything metallic.
ERASE PROTECTION
· To prevent accidental erasing of a cassette, simply break off the two plastic tabs located on the cassette tape s rear
side.
· When a cassette with removed plastic tabs is inserted, the recording button cannot be pressed.
· If a cassette is to be erased and re-recorded at a later stage, simply cover the holes on the cassette where the tabs
were removed, with a piece of strong adhesive tape.