Philips 1250X-45 User Manual

Page 15

Advertising
background image

ENGLISH

Cleaning the Shaving Unit in the

Jet Clean System (1280XCC and

1250XCC)

CAUTION: Keep cleaning solution out of

reach of children. Do not take internally. Avoid

contact with eyes. In case of eye contact,

thoroughly flush with cold water. If irritation

persists, get medical attention.

Important

Only use this razor, charging stand, Jet Clean

System and HQ200 cleaning solution provided

to charge or clean razor.

Other Philips Norelco razors DO NOT work

with this Jet Clean System.

Empty the cleaning solution canister and

thoroughly rinse the canister clean with warm

water every 2 weeks.

The Jet Clean System thoroughly cleans but

does not disinfect your razor, therefore, do not

share razor with others.

The charging plug converts 100-240V AC to

less than 24V DC.

Place the Jet Clean System on a flat, stable and

fluid-resistant surface to avoid any leakage. Be

careful not to tip or move the Jet Clean System

if it is filled with the cleaning solution.

To avoid evaporation, do not expose cleaning

solution to direct sunlight.

Remove the protective razor head cap from

the razor before charging or cleaning the

razor in the Jet Clean System.

28

ENGLISH

Use this appliance for its intended household

use as described in this manual.

1

Place the Jet Clean System on a flat, level

surface.

C

2

Simultaneously press the buttons located

on both sides of the Jet Clean System

(

1) and lift the appliance off the Jet Clean

canister (2).

Always remove appliance from canister by lifting

straight up. Do not tilt Jet Clean System.

3

Unscrew the lid on the Jet Clean Solution

bottle (Model HQ200) provided with the

razor. Remove the airtight seal by lifting up

the tabs on the seal.

C

4

Pour the Jet Clean Solution into the canister

up to a level between the two lines located

inside the canister.

NOTE: ONLY USE PHILIPS NORELCO JET

CLEAN SOLUTION (MODEL HQ200) WITH

THE JET CLEAN SYSTEM. ANY OTHER

SOLUTION MAY CAUSE DAMAGE TO YOUR

RAZOR.

C

When the cleaning solution level drops below

the minimum level, the ‘cleaning chamber

empty’ symbol will blink and the razor holder

will move to the starting position.

29

Advertising