Beyerdynamic SIR 320 - Manual (Page 21)

Copyright by beyerdynamic
21
Exit the service mode
Press “CH
” to scroll to “En” flashing alternately with “nd” in the display. At this position you can
leave the Service mode by pressing the “VOL”, “VOL” or “CH
” key. The IR- receiver will
return to the newly adjusted settings in the operation mode.
The display back light illuminates and the display itself
shows the version number and afterwards turns back to the
starting channel.
Display of Exit service mode
If you do not leave the Service mode as described above, the receiver will return after approx. 2
minutes automatically to the normal operation mode and all settings will be stored.
Hardware reset
In case the receiver fails to respond to button push please carry out a hardware reset to factory default
settings. The hardware reset brings back all factory defaults and is activated by the keys “VOL” and
“VOL” simultaneously.
Behaviour in the charging tray
In the charging tray (SIR C 50) the receiver shows “bA” alternating with “XX” (battery voltage) in the display
e.g. 37.
If you take out the receiver from the charging tray the receiver switches off itself.
If you put the receiver in the charging tray, it switches directly into the charging mode.
Display: “bA” and “XX” (battery voltage) alternately