Breville JE16 - Manual (Page 10)

10
USING YOUR PROFESSIONAL JUICER
EMPTYING THE PULP COLLECTOR
Always check the level of juice in the Juice Collector Jug. Do not overfill, as juice will
continue to drip from the juice outlet after you have stopped juicing. Switch off the
appliance and allow the dripping to stop before removing the Juice Collector Jug.
When the Pulp Collector starts getting full, switch off the appliance, empty the Pulp
Collector.
Hold the Pulp Collector, tilt (1) the Pulp Collector a bit and move it away (2) from the
appliance, as shown below.
NOTE: Take care not to spill content in the Pulp Collector when tilting.
To refit, place back onto the rear of the Motor Base. Ensure that the lug on the bottom
of the Pulp Collector fits into the slot at the rear of the Motor Base.
JE16_New.pmd 3/24/2006, 4:17 PM 10