Philips SHC1300-61 - Manual (Page 5)

5
Transmitter (figure 1)
1 IR transmitting LEDs – transmit
audio signal to IR headphone.
2 DC power – connect to the 12 Volt/
200 mA AC/DC adapter.
3 Power switch – power on/off switch.
4 3.5 mm stereo headphone audio
input – connects your IR transmitter to
an audio source.
5 Controls plate
Headphone (figure 2)
6 IR sensors – to receive IR waves from
the transmitter.
7 Power indication – lights up when in
use.
8 Power On/Off – slide the switch to
the on or off position to switch the
headphone on/off.
9 Volume – adjust volume to your
desired listening level.
Transmitter power supply
IMPORTANT
Use only Philips SBC CS030/00
12 Volt/200 mA AC/DC adapter.
(For UK, use only Philips SBC
CS030/05)
1 Make sure the adapter’s rated voltage
corresponds to the mains socket
voltage.
2 Connect the DC connector of the
AC/DC adapter to the 12 Volt DC
power input connector located at the
rear of the transmitter.
3 Connect the 12 Volt/200 mA AC/DC
adapter to the mains socket.
– Always disconnect the AC/DC
adapter if the transmitter is not to be
used for a long period of time.
Headphone power supply
1 Check if the power button of the
IR headphone is in the on position.
2 Ensure the batteries are put in the
battery compartment correctly
according to the engraved polarity
symbols.
Note:
Always remove the batteries if the
headphone is not to be used for a long
period of time.
Batteries contain chemical
substances, so they should be
disposed of properly.
Controls Installation
English
Environmental Information
All redundant packing material has been omitted.We have done our best to
make the packaging easily separable into two materials: cardboard and
polyethylene.
Your unit consists of materials which can be recycled if disassembled by a
specialized company. Please observe the local regulations regarding the
disposal of packing materials, exhausted batteries and old equipment.
SHC1300_booklet 12-01-2006 11:08 Pagina 5