Philips HTS6120-37 - Manual (Page 39)

39
[HDMI Audio]
Selects the HDMI audio setting when you
connect this Home Theater System and the
TV with a HDMI cable.
• [On] – Allows audio output through the
TV and the speaker system. If the audio
format on the disc is not supported, it
will be downmixed to two-channel sound
(linear-PCM).
• [Off] – Disables audio output from the
TV. The sound is only output through the
speaker system.
[Night Mode]
Makes loud sound level softer and soft sound
level louder so that you can watch the DVD
movies at a low volume, without disturbing
others.
• [On] – Enjoys quiet viewing at night.
• [Off] – Enjoys surround sound with a full
dynamic range.
Note
Applicable only to Dolby Digital encoded discs. •
Audio setup
1
Press SETUP .
» [General Setup] menu is displayed.
2
Press to select [Audio Setup] , then
press .
3
Select an option, then press OK .
4
Select a setting, then press OK .
To return to the previous menu, •
press BACK .
To exit the menu, press
• SETUP .
Note
See the explanations of the above options in •
the following pages.
[Ambisound Setup]
Optimizes the Ambisound based on this
Home Theater System setup in the room (see
‘Getting Started’ > ‘Start Ambisound setup’).
Option Description
[Setup
Guide] Guides you through the
complete setup requirements.
[Room
Acoustics] Selects the type of walls that
surround the room.
[Room
Placement] Selects the placement in the
room.
[Height] Selects the height at which it is
placed.
[Listening
Position] Selects the distance between
the listening postion and this
Home Theater System.
HDMI Audio
Ambisound Setup
Night Mode
Audio Setup
Adjust settings
English
EN