Operation, Front panel controls – Bogen C35 User Manual
Page 8
Operation
Front Panel Controls
Power
The front panel ON/OFF switch applies power to the amplifier and is illumi-
nated when power is ON.
Input Volume Controls
Each input module may be individually controlled by its corresponding volume
control knob.
MIC2,AUX 1 Mode Switch
Activates the corresponding input that it is switched to - MIC2 or AUX1.The
other input is inactive and any connections to the inactive input will not work.
Bass and Treble Controls
The Bass and Treble controls are used to adjust the tonal balance of the ampli-
fier output. The center position of these controls provides flat frequency
response. Counterclockwise rotation of these controls reduces the bass or
treble response, while clockwise rotation increases such response.
The treble control has a cut/boost range of +/- 11 dB at frequencies above
1
0 kHz and provides a roll off after 20 kHz to reduce gain above the audio
range.
The bass control has a cut/boost range of +/- 11 dB at frequencies below 100
Hz. When driving speakers using the direct-coupled output terminals, the bass
filter’s response is flat to 20 Hz.
6