Philips DS6800W-37 - Manual (Page 10)

9
English
EN
4 Connect to
your home Wi-
Fi network for
AirPlay
To connect DS6800W to your existing home
Wi-Fi network, you need to apply your home
Wi-Fi setting to DS6800W.
You can do this in two ways (depending on
which type of Wi-Fi router you use):
• Automatically - if your Wi-Fi router is
WPS (Wi-Fi Protected Setup)-enabled
and supports PBC (Push Button
Connection) (see 'Scenario 1: Connect
to a WPS router' on page 9 )
• Manually - if your Wi-Fi router does
not support WPS (see 'Scenario 2:
Connect to a non-WPS router' on
page 10 )
Once connected successfully, DS6800W will
remember your home Wi-Fi settings. Then
you can enjoy AirPlay whenever DS6800W is
powered on and connected to your home Wi-
Fi network automatically.
Before connection of DS6800W to you home
Wi-Fi network, check the points below.
1
Make sure that your Wi-Fi router is
powered on and working properly.
2
Make sure that DS6800W has been
powered on and booted up successfully
(see 'Turn DS6800W on' on page 8 ) .
3
Identify the type of your Wi-Fi router (see
the user manual of your Wi-Fi router for
details).
Scenario 1: Connect to a
WPS router
Note
• Before you press any button on DS6800W, make sure
that DS6800W has been booted up successfully (see
'Turn DS6800W on' on page 8 ) .
1
Press the WPS button on your home Wi-Fi
router.
2
Shortly after step 1, press Wi-Fi SETUP on
the back of the main speaker.
» The Wi-Fi SETUP indicator blinks red,
yellow and green alternately.
» Within 2 minutes, the WI-FI SETUP
indicator stops blinking and stays green,
and the unit beeps.
» DS6800W is connected to your home
Wi-Fi network successfully.
WPS
DS6800W_37_UM_Book.indb 9 2011-9-14 10:53:27