Philips DVP3980-37 - Manual (Page 35)

E
ng
li
sh
35
Setup Menu Options
(continued)
Audio Setup Page (underlined options are the factory default settings)
This setting is only required if you have connected the audio
output of this unit to a stereo device or TV using the analog
output jack.
{ LT/RT } – The connected device has a built-in
Dolby Pro Logic decoder. It can deliver
the surround sound through the two
speakers.
{ Stereo } – The connected device can only output
stereo audio through two speakers.
{ V SURR } – For virtual surround sound effects.
This setting is only required if you have connected the audio
output of this unit to an amplifi er/receiver using the digital
output jack.
{ Digital Output } – { Off }
Disable digital audio output. Select this
if you are using the analog audio jacks
to connect this unit to a TV or Stereo
system.
{ ALL }
The connected device supports multi-
channel audio formats. The digital audio
format will be output as on disc.
{ PCM Only }
The connected device does not support
multi-channel formats. All audio signals are
downmixed to PCM format (2-channel).
{ LPCM Output } – { 48 K }
Select this to play disc recorded at
sampling rate of 48 kHz.
{ 96 K }
Enable 96 kHz output on digital audio if
the amplifi er/receiver is compatible
with high sampling rate audio (88.2 / 96
kHz). However, if the sound output is
distorted or there is no sound, change
the setting to ‘48 K’.
Notes:
– Digital Audio Setup setting is only available if HDMI Audio is set
to { Off }.
– LPCM Output can only be selected when { PCM Only } is
activated. The higher the sampling rate, the better the sound quality.
Analog Output
Digital Audio Setup