Philips VRX462AT99 - Manual (Page 43)

TO SELECT PUSH NO. SHOWN
1 SET REPEAT PLAY (OFF)
2 ON SCREEN MODE
3 LANGUAGE
4 SET VCR PLUS+ CH
5 SET CABLE BOX
6 SET DSS RECEIVER
7 AUDIO OUT
8 VIDEO STABILIZER (OFF)
TO END PUSH EXIT
CABLE BOX CONTROLLER
OFF
TO SELECT PRESS NUMBER
1 ON
2 OFF
TO CONTINUE PUSH MENU
TO END PUSH EXIT
• If the EXIT/STATUS button is
pressed during steps 6 - 9, “CABLE
BOX CONTROL IS OFF” will appear
on-screen for five seconds. You will
return to TV programming.
• If the remote control does not oper-
ate the Cable Box, the Controller
will not change channels at the
Cable Box during a timer recording.
In this case, you must select the
channel to be recorded at the Cable
Box before a timer recording begins.
Leave the Cable Box on for the
timer recording.
Helpful Hints
• If you use a Cable Box, you must set the clock manually. Details
are on page 14.
• Complete the steps on page 27 before proceeding. This will
enable you to use the VCR remote control to operate the
Cable Box, and you will learn your Cable Box code.
• Make each entry within one minute of the previous entry.
1
Turn on the Cable Box. Select a channel other than 09.
2
Press the VCR button, then press the MENU button.
3
Press the Number 2 button to select VCR SET UP.
4
Press the Number 5 button to select SET CABLE BOX.
5
Press the Number 1 button to set the Cable Box
Controller to ON.
Setting the Controller to Operate a Cable Box 43
...
...
POWER
CBL/DSS VCR TV
EJECT MUTE
MENU EXIT/STATUS CLEAR
VCR PLUS+
/ENTER LIGHT
F.ADV
PAUSE/STILL
1 2 3
4 5 6
7 8 9
100 0 GO-TO
MEMORY INDEX
VAR. SLOW
REMOTE LOCATOR
SKIP
VCR/TV SPEED SEARCH SLOW
TRACKING
STOP
REW FF
PLAY
VOL CHANNEL
/OTR REC
6
Press the MENU button.
6
4
3
5
2
1 Turn on the Cable Box. Set it
to a channel other than chan-
nel 9.
Instructions continue on page 44.
CABLE BOX CONTROLLER
ON
TO SELECT PRESS NUMBER
1 ON
2 OFF
TO CONTINUE PUSH MENU
TO END PUSH EXIT
SELECT CODE NUMBER
OF YOUR CABLE BOX
--
TO END PUSH EXIT