Belkin DockStation F5U216 - Manual (Page 9)

5
En
HARDWARE INSTALLATION
• Connect the VGA cable from your desktop monitor into the “VGA In”
port on the DockStation (See fig. 1).
• Connect the “VGA Out” cable on the DockStation to the VGA connector
on your computer.
• Plug the DockStation power supply into an available AC wall outlet or
surge suppressor. Plug the power supply’s DC power plug into the
“Power In” connector on the DockStation (See fig. 1).
Note: Do not connect the DockStation’s USB cable to your computer at this
time. Proceed to the “Driver Installation” section of this User
Manual, and install drivers for your version of Windows before
completing the hardware installation procedure.
Note: Do not connect any peripheral devices into the DockStation until
after completing the driver installation procedure, and restarting
Windows.
VGA IN
ETHERNET
USB I
USB II
VGA OUT
POWER IN
UPSTREAM
fig. 1
P74321ea_F5U216_manual_uk 02-06-2003 15:59 Page 5