Behringer Eurogrand EG2080-RW/BK - Manual (Page 7)

7
EUROGRAND EG2080- RW/BK
7) Secure the playing console to the metal brackets on the side
panels from below using the four S4 screws.
S3
S2
S1
S1
S2
S4
Fig. 2.2: Assembling the EG2080
This section describes how to assemble the piano step by step.
1) Put the two side panels  +  on the floor and use the
four S1 screws to screw the pedal unit  to the two side
panels.
2) Route the cable of the pedal unit to the outside (bottom
side), so that it is lying loosely on the floor.
3) Stand the frame comprising side panels and pedal unit
upright.
4) Put the rear panel  , slightly inclined, on the feet of the two
side panels, then tilt the upper part of the rear panel towards
the metal brackets on the two side panels.
5) Secure the rear panel with four S2 screws (top) to the metal
brackets on the side panels, and with the six S3 screws to
the pedal unit.
6) Carefully lift the playing console  onto the frame. This
should be done by two persons. First, place the front side of
the playing console – coming from the rear side of the frame
– onto the side panels, then slide the playing console carefully
towards the front. If necessary, use your foot to stop the
frame from moving forward. Always make sure that the
projecting pins on the underside of the playing console are
inserted into the guiding rails in the brackets.
2. ASSEMBLY INSTRUCTIONS