Bissell Powerforce Turbo bagless 6585 series - Manual (Page 11)

11
w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1
Check rotating floor brush and drive belt
You should check your vacuum cleaner’s rotating
floor brush and drive belt regularly for wear or
damage. You should also clean the brush and
brush ends of string, hair, and carpet fibers. These
can wrap around the brush and hamper its ability
to effectively clean your carpet.
Also remove any
debris that has accumulated under the brush cover.
1. Unplug cleaner from electrical outlet.
2. Place handle in low position and turn vacuum
cleaner over so bottom side is up.
3. Lift tab 1 and release the three latches in
order 2-4 marked. Lift off the brush cover.
4. Grasp rotating floor brush at both ends and lift.
5. Clean strings, hair and other debris from
rotating floor brush, paying particular
attention to brush ends.
6. Clean strings, hair and other debris from motor
pulley and drive belt areas.
7. Check drive belt carefully for wear, cuts or
stressed areas. Replace if worn.
8. Check air passageway for obstructions.
Remove debris from this area.
Replace drive belt
Use only BISSELL Style 10 Replacement
Belts (#32074) in your BISSELL PowerForce
Turbo Bagless.
1. Unplug cleaner from electrical outlet.
2. With rotating floor brush removed from vacuum
cleaner (Steps 1-4 of Check rotating floor brush
and drive belt), grasp old drive belt and remove
from motor pulley. Discard old drive belt.
3. Place new drive belt over motor pulley and
stretch other end over rotating floor brush in
the space between the bristles.
4. Place ends of rotating floor brush down into
slots on sides as shown.
5. Turn rotating floor brush by hand several times
in direction of motor pulley. If properly installed,
drive belt will center itself on rotating brush.
6. Reposition brush cover and four screws. Make
sure end of brush cover is snapped into place.
M
aintenance and care
Press here
Brush
Cover
Motor
Pulley
Air Passageway
Brush
Cover
2
1
3 4
ug110_4018_6585_1207.indd 11 ug110_4018_6585_1207.indd 11 12/19/07 10:04:58 AM 12/19/07 10:04:58 AM