Philips MCM590-37B - Manual (Page 19)

19
English
Programming the disc tracks
Programming tracks is possible when playback is
stopped. Up to 99 tracks can be stored in the
memory in any order.
IMPORTANT!
It is only possible to programme from
the current selected disc tray.
DISC 1
DISC 5
DISC 1
DISC 2
DISC 3
DISC 4
1
2
3
5
4
DISC 2 DISC 3 DISC 4 DISC 5
CD / CD-R / CD-RW COMPATIBLE
5 D I S C D I R E C T P L AY
OPEN/ CLOSE
DISC 5
DISC 2
DISC 3
DISC 4 3
POWER ON/OFF
DISC 1
1
2
4
6 8
7
3 5 ,
1
Load the desired discs on the disc trays (refer to
“Loading discs”).
2
Press CD or one of the DISC 1~5 buttons to
select a disc.
3
Press PROGRAM (PROG) to start
programming.
➜
PROG starts flashing.
4
Press í or ë repeatedly to select the desired
track.
● For MP3 disc, press а / б (ALBUM 43) and
н / л (TITLE -+) to select the desired
album and title for programming.
5
Press PROGRAM (PROG) to store.
● Repeat steps 4~5 to select other tracks.
➜ If you attempt to programme more than 99
tracks, " PROGRAM FULL" is displayed.
6
Press 9 to exit the program mode.
➜ PROG stops flashing.
7
To start programme play, press ÉÅ.
8
To stop playback or to end the programming,
press
9 once.
➜
PROG stays and the programme mode
remains active.
Notes:
– If the total playing time reached 100 minutes or
if one of the programmed tracks has a number
greater than 30, then "
--:--" is displayed instead
of the total playing time.
– The system will exit programming mode if no
button is pressed within 20 seconds.
Checking the programme
1
Stop playback and press í or ë repeatedly.
2
Press Ç to exit.
OR
Press ÉÅ to start playback from the current
programmed track
Clearing the programme
●
Stop playback, then press Ç to clear the
programme.
OR
Press the OPEN/CLOSE 0 button of the disc
tray.
➜
PROG disappears and "
PROGRAM CLEARED"
is displayed.
Note:
– The programme will be erased if the system is
disconnected from the power supply or you switch
to another source mode.
Disc Operations