Fine-tuning your system – Bose AM262838_00_V. User Manual

Page 18

Advertising
background image

16

December 20, 2001

AM262838_00_V.pdf

Fine-tuning your system

In most situations, you only need to follow the speaker placement guidelines for your system
to provide excellent sound quality.

You do not need to adjust tone settings for changes in volume, since Bose

®

patented signal

processing technology provides a natural tonal balance over the full range of volume settings.

If desired, you can further fine-tune your system as described below.

Adjusting speaker controls

The TREBLE and BASS controls are located on the Acoustimass

®

5 and 20 music systems’

Acoustimass module (Figure 19). They allow you to adjust the treble (high frequencies) and
bass (low frequencies). In the normal setting, the dots on each control are in the 12-o’clock
position. Turn the controls clockwise to increase and counterclockwise to decrease the
amount of treble or bass.

Compensating for room acoustics

The acoustics (sound qualities) of your room can affect the overall sound quality of any
speaker system. In general, you can reduce many problems with acoustics by the careful use
of the TREBLE and BASS controls.

Too much or too little treble

Rooms with too few sound-absorbing furnishings, especially those with bare floors and walls,
may sound overly shrill or “bright.” Turning down the treble control (toward –) decreases
treble sound.

Rooms with a lot of sound-absorbing furnishings, such as upholstered furniture, wall-to-wall
carpet, or heavy drapes, may reduce the treble sound of your system. Moving speakers
farther away from soft furnishings increases treble. You can increase treble sound by slightly
turning up the treble control (toward +).

Too much or too little bass

You can decrease bass sound by turning down the bass control (toward –). To increase bass,
turn up the bass control (toward +).

Acoustimass module placement affects the amount of bass you hear. Placing the module
closer to the corner of the room will increase bass. Moving the module away from the corner
will decrease bass.

Figure 19

Bass and treble controls

®

Treble

Bass

Setting Up

Setting Up

English

Advertising