Hale 5.0 FoamLogix User Manual
Foamlogix, Description, installation and operation manual
6/26/2003
HALE PRODUCTS, INC.
l
A Unit of IDEX Corporation
l
700 Spring Mill Avenue
l
Conshohocken, PA 19428
l
TEL: 610-825-6300
l
FAX: 610-825-6440
MANUAL P/N 029-0020-68-0, REV B, © 2003 HALE PRODUCTS, INC., PRINTED IN U.S.A.
O
N
O
C
E
V
E
R
M
O
R
F
D
E
G
N
A
H
C
Y
B
E
T
A
D
D
V
P
A
7
3
1
-
3
0
A
G
N
I
T
N
I
R
P
R
O
F
D
E
S
A
E
L
E
R
W
R
P
3
0
0
2
/
2
0
/
5
L
A
M
5
1
2
-
3
0
B
D
E
T
A
D
P
U
W
R
P
3
0
0
2
/
0
3
/
6
L
A
M
Hale Products cannot assume responsibility for product failure resulting from improper
maintenance or operation. Hale Products is responsible only to the limits stated in the product
warranty. Product specifications contained in this material are subject to change without notice.
All Hale products are quality components: ruggedly designed, accurately machined, precision inspected, carefully assembled
and thoroughly tested. In order to maintain the high quality of your unit, and to keep it in a ready condition, it is important to
follow the instructions on care and operation. Proper use and good preventive maintenance will lengthen the life of your unit.
ALWAYS INCLUDE THE UNIT SERIAL NUMBER IN CORRESPONDENCE.
DESCRIPTION, INSTALLATION AND
OPERATION MANUAL
MODEL 3.3 AND 5.0 ROTARY GEAR
PUMP ELECTRONIC FOAM
PROPORTIONING SYSTEM
Hale FoamLogix System Serial Number: _____________________________
Date Unit Placed in Service: _______________________________________
Fire Department: ________________________________________________
Engine Number: ________________________________________________
Calibration Factors:
Water Flow Factor: __________________________________________
Class A Foam Factor: ________________________________________
Class B Foam Factor: _______________________________________
NOTICE:
This manual is divided into four sections for clarity and ease of use. Section
I: DESCRIPTION; Provides an
introduction to the Hale foam proportioning system along with guidelines for designing and ordering a complete
system. Section
II: INSTALLATION; Provides information to assist the OEM with installation and initial set-up of Hale foam
proportioning systems on an apparatus. Section
III: SET-UP AND CALIBRATION; Is used by the installer and end user for
start-up and calibration of the Hale foam proportioning system. Section
IV: OPERATION; Is primarily used by the
apparatus user for proper operation and maintenance of the Hale foam proportioning system. Each manual section
can be a stand alone section or can be used in conjunction with each other.
FoamLogix
TM