Prepare to install kit bracket – OR-Fab 87046 2012-2015 Jeep JK Vacuum Pump Relocation Kit User Manual
Page 2
2012 Vacuum Pump Relocation Kit
2
Kit #87046
b. Using a 10mm wrench, remove two OEM nuts
from studs in frame bracket and remove vacuum
pump from studs.
c. Using a cut off wheel, cut and remove pump
frame bracket from inside of drivers side frame
rail.
NOTE: Save two OEM 6mm nuts for remounting pump.
Prepare to Install Kit Bracket
1. Cut and extend pump wire harness.
Vacuum
Hoses
Remove Two
Nuts
Vacuum
Pump
Vacuum
Pump
Harness
Frame
Bracket
Frame
Bracket
Removed
Drivers Side
Frame Rail
a. Using a pair of wire cutters, remove the section
of wire loom and cut both wires leaving approxi-
mately 2” of wire after the connector.
b. Using four kit connectors and kit wires (Black &
White), strip, connect and extend wires using a
crimp tool.
c. Reroute extended kit wires up through fender
and place near PCM plug harness in the engine
compartment.
d. Drill two 1/4” holes 3/4” a part into plastic casing
near PCM / ABS module to relocate plug har-
ness into engine compartment.
e. Remove vacuum connector clip and one way
valve from end of vacuum hose.
Cut Wire
Harness
Extend Kit
Wire Harness
Kit
Connectors
Pump Harness
Plug
Drill two 1/4”
Holes
Pump Harness
Plug Mounted