OR-Fab 88002 ROCK DOOR KIT - JEEP - FRONT JEEP JK WRANGLER / UNLIMITED - Manual (Page 4)

CJ, YJ, TJ, JK Rock Door 4 Kit 88000, 88001, 88002
j. Install kit latch (driver) onto kit door (driver) with
three kit bolts (1/4”-20 x 1”), three kit washers
(1/4” SAE) and any additional kit washers (1/4”
SAE) to set kit latch to catch.
k. Adjust kit latch (driver), TIGHTEN kit bolts (1/
4”-20 x 1”) and test kit door (driver). Readjust kit
latch (driver) as necessary to obtain proper
latch with catch.
TJ Models:
l. Install kit latch (driver) onto kit door (driver) with
two kit bolts (1/4”-20 x 1”) and two kit washers
(1/4” SAE). DO NOT TIGHTEN.
m. Adjust kit latch (driver), TIGHTEN kit bolts (1/
4”-20 x 1”) and test kit door (driver). Readjust kit
latch (driver) as necessary to obtain proper
latch with catch.
Kit Door
(Driver)
Kit Bolts
(1/4”-20 x 1”),
Kit Washers
(1/4”SAE)
Kit Latch
(Driver)
Catch
Kit Door
(Driver)
Kit Latch
(Driver)
Kit Bolts
(1/4”-20 x 1”),
Kit Washers
(1/4” SAE)
JK Models:
n. Install kit latch (driver) onto kit door (driver) with
two kit bolts (1/4”-20 x 1”), two kit spacers, and
two kit washers (1/4” SAE). DO NOT TIGHTEN.
o. Adjust kit latch (driver), TIGHTEN kit bolts (1/
4”-20 x 1”) and test kit door (driver). Readjust kit
latch (driver) as necessary to obtain proper
latch with catch.
All Models:
p. Open and close kit door (driver) ensuring proper
kit latch (driver) operation.
NOTE
Kit latches have two stages. The first stage will result
in kit doors not seated completely against kit plug.
The second stage will properly seat the kit doors
against the body. Adjust kit latches and kit hinges if
the second stage is not attainable.
Two Kit Spac-
ers
Kit Latch
(Driver)
Kit Bolts
(1/4”-20 x 1”),
Kit Washers
(1/4” SAE)