Kastor Takat Opera Fireplace User Manual

Page 21

Advertising
background image

11/07

Art nr K0006127

21

4. WARRANTY

The product's warranty is in accordance with present consumer protection regulations. The warranty only apples, if the user manual's instructions
have been followed.

5. MANUFACTURER'S ASSURANCE

This product fulfils all requirements set down in the acceptance protocol and all appended documents.


6. TROUBLESHOOTING

The fireplace leaks smoke right after installation or after long term use:

- The chimney's length must be over 3.5 m with a surface are of 120–180 cm²
- Is the damper plate open? Open the chimney's damper plate.
- Check whether the chimney has been swept and that there are no obstructions in it. Remove obstructions/sweep chimney.
- External circumstances, such as a nearby house or park may influence the chimney's draught properties. Lengthen chimney.
- Check the seals of the exhaust flue connection. Reseal the attachments.
- During the ignition phase and the proper heating, a suitable humidity for the firewood is 15-20 %. Use sufficiently dry wood.
- The apartment has devices that cause low air pressure such as air conditioning or a range hood. Turn these off or open a

window during the ignition phase.

- The chamber above the flame regulator plate has not been cleaned after the chimney sweeping. Remove the insulation

plates from the furnace and clean it.

- The combustion air pipe coming from outdoors is plugged up. Detach the pipe and check the burning. Clean the pipe and

any grates in it.

- Is the combustion air regulator open? Open the regulator and grate completely for the ignition phase.
- A wind gust may weaken the draught for a moment.

A lot of soot accumulates on the glass:


Some soot always accrues during use. Reasons for strong soot accumulation may be:

- The wood is moist and produces a lot of smoke.
- The burn temperature is too low, which means that draught is weak and the wood burns badly and produces soot.

Light and run the fireplace according to instructions, that is use enough wood during burning. Add wood on the embers to get quick
ignition. See that the wood humidity is correct.

We thank you for your confidence in Kastor products.

Advertising