Briggs & Stratton 71009 - Manual (Page 12)

12
TROUBLESHOOTING
TROUBLESHOOTING
Problem Cause Correction
Automatic transfer switch does
not transfer to generator 1. Generator breaker open.
2. Generator voltage not acceptable.
1. Reset generator circuit breaker.
2. Refer to generator manual.
Automatic transfer switch does
not transfer to utility
1. Utility disconnect breaker open
(Models 071010 & 071011 only).
2. Service disconnect breaker open.
3. Utility voltage not acceptable.
1. Reset utility disconnect breaker
(Models 071010 & 071011 only).
2. Reset service disconnect breaker.
3. Wait for utility voltage to return to
normal.
Generator is still running after
switch transfers to utility power Engine cool down period. Engine should stop after 1 minute.
Supervised loads (air conditioner,
etc.) are not operating when
generator is supplying power
1. A-A or B-B contacts not operating
correctly.
2. Too much load on generator.
3. Current transformer not
connected.
4. Broken current transformer.
1. Check A-A or B-B contacts for
proper operation and/or check
control wiring to external load.
2. Decrease load to generator.
3. Contact local Briggs & Stratton
Power Products service center.
4. Contact local Briggs & Stratton
Power Products service center.
Generator is still running after
utility power is restored
1. Minimum engine run time has not
elapsed.
2. Fuse(s) in transfer switch is
defective.
1. Wait five minutes for transfer
switch to retransfer to utility
power.
2. Check fuse(s) and replace if
necessary.