ARB 4413270 - Manual (Page 2)

11-01-06 Page 2 of 4 3783019
ASSEMBLY SEQUENCE FOR SIDE RAIL AND STEP.
1. Lay the side step next to the vehicle in
position to see the approximate location of
the “U” bolts on the chassis. Fit the “U”
bolts to the chassis as shown.
WARNING
When fitting the “U” bolts to the chassis on
the left hand side of the vehicle, make sure
the “U” bolts fit under all cables and steel
brake lines giving plenty of clearance.
DO NOT CRUSH PIPING OR WIRING.
2. Fit the rubber plugs into the ends of the side
steps and also into the end of the front rail
that meets the bull bar.
3. With help, support the front of the step. Bolt
the rear bracket loosely into position using
½” flat washer, spring washer and M12 nut.
Finger tighten only.
4. Repeat this for both the front bracket and
center bracket. Once all brackets are
attached align the side rail to the vehicle and
tighten firmly.
NOTE:- Due to chassis variations the step
may need to be fitted with a spacer on one
side, to maintain a consistent gap from the
left hand to right hand side. These are
supplied in the kit, depending on the gap
one or two spacers per bracket will be used.
The spacer is placed between the chassis
rail and the side step bracket.
The front and center bracket use the long
spacer (319 3721) the rear bracket uses the
smaller type similar to the ones welded to
the rear bracket, and locate in the same
position.