ARB 5421110 - Manual (Page 4)

Last Rev Date: 14/01/14 Page 4 of 8 Fitting instructions# 3787952
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
FITTING PROCEDURE
1. ALL VEHICLES: Remove O.E panels from
vehicle and retain bolts. If fitted with a bullbar
remove and retain two lower M6 bolts (M8 for
Prado 120) and loosen off the top four M6
bolts on the bullbar stone shield.
2. PRADO 150 WITH KINETIC. Fit two M6
cage nuts to front mounting bracket of panel
as shown.
3. Lift front panel into position while placing (if
fitted) the bullbar stone shield between the
panel and front mounting bracket. Secure
panel to chassis using original fasteners and
stone shield with M6 bolts removed in step 1.
Leave all fasteners finger tight.
4. FJ CRUISER. Fit two M6 cage nuts into front
panel as shown. NOTE: There are two types
of stone shields. Measure distance between
O.E stone shield and place cage nuts in
correct holes.
BULLBAR STONE SHIELD
TO FRONT UVP
STONE SHIELD
FRONT UVP