Steele Products SP-CE358TM - Manual (Page 17)

17
Owner’s Manual
Compressor (cont’d)
Assembling the Compressor (cont’d)
Using the Air Tank
1) Turn the air valve switch to the “OFF” position. 2) Disconnect hose from top tank.
3) Disconnect hose from top tank. To use air tank
turn the valve to the “ON” position. 3) Release latch to remove detachable air tank.
OFF
ON
1) Check the compressor’s serial label to ensure that you have received the model ordered, and that
it has the required pressure rating for its intended use.
2) Place the compressor according to the following guidelines:
a. Position the compressor near a grounded electrical outlet.
b. The compressor must be at least 12 inches (31 cm) from any wall or obstruction, in a clean, dry
ventilated area, to ensure sufficient air flow and cooling.
c. In cold climates, store portable compressors in a heated building when not in use. This will
reduce problems with motor starting and freezing of water condensation.
d. Remove the compressor from the shipping pallet or carton and place it on the floor or a hard,
level surface. The compressor must be level to ensure proper drainage of the moisture in the tank.
3) Connect an air hose to the compressor hose outlet.
ON
OFF